Comtech EF Data Radyne DMD1050, Installation And Operation Manual

Page: 21 / 183

DMD1050 Satellite Modem Board Installation
2.6.3 M&C Terminal Setup
The initial field checkout of the modem can also be accomplished from the Terminal Mode. The
Terminal Mode has the advantage of providing full screen access to the modem’s parameters, but
requires a separate terminal or computer running a Terminal Program such as Hyper-terminal and
connection to the applicable pins on the M&C connector J1. The recommended terminal setup is
as follows (These settings can be changed via the Web Browser):
Emulation Type: VT-100
Baud Rate: 19.2 K
Data Bits: 8
Parity: No Parity (Fixed)
Web Browser and Terminal Interfaces Reset
If you cannot access the Web Browser or Terminal interface, reset the
interface defaults. To reset the interface defaults, use the shorting plug
(CNRSHUNT). Obey these steps:
1. Make sure the electrical power to the unit is disconnected.
2. Find the JP5 and JP6 connectors.
3. Find pins 1 and 2 on the JP5 and JP6 connectors.
4. Install the CNRSHUNT shorting plug on pins 1 and 2 of JP5 and pins
1 and 2 of JP6.
5. Connect the electrical power to the unit.
6. This will reset the interface defaults.
See Section 3 for more information.
IMPORTANT
MN-DMD1050 2–5
Revision 9