Comtech EF Data Radyne DMD1050, Installation And Operation Manual

Page: 152 / 183

DMD1050 Satellite Modem Board Web Browser Setup Guide
3. Turn on power to the DMD1050 and allow it to run for 2 minutes.
4. Turn off power and remover the Reset mating connector from JP5 & JP6.
5. The IP addresses are now configured to the following:
Boot Modes: IPTEST
Bootp Server Tag: 206
IP Address Mask: 255.255.255.000
Modem IP Address: 192.168.0.238
Server IP Address: 192.168.000.101
Router IP Address: 192.168.000.102
6. In order for the computer to recognize the modem, the computers subnet Mask must match the
Subnet Mask of the modem. The IP Address Mask is 255.255.255.000. To ensure the safety of
the network, it may be necessary to contact the network administrator.
7. Turn on the unit. The unit is now ready to connect to the computer. Connect the RJ45 cable from
the DMD1050 to the computer/router/bridge as illustrated in Figure D-1.
Figure D-1. Ethernet Connection
8. Initiate PING test to ensure there is communication between the modem and the computer
Example: ping 192.168.0.238
If everything is functioning correctly, replies from the modem will appear on the computer screen
along with the time it took to respond. If unsuccessful, verify the following:
A. The cables are secured.
B. The Link Light is illuminated.
C. The IP Address that is used matches the Modem’s IP Address.
D. The Server and Modem are on the same subnet.
MN-DMD1050 D–2
Revision 9