Comtech EF Data Radyne DMD1050, Installation And Operation Manual

Page: 104 / 183

DMD1050 Satellite Modem Board Web Browser
7.3.4 Monitor and Control Menu
Under this menu, all modem functions that are monitored and/or controlled are accessible. To
access the M&C sub menu options drag the cursor across the gel-tabs. Note that as the cursor
passes over a tab it is highlighted and a menu drops below the tab. Stop on the desired tab move
the cursor down and then across to the desired function. Select the desired sub menu function and
the data entry menu will appear in the data entry section allowing for adjustments to the
parameters displayed.
7.3.4.1 Transmit Menu
The Transmit menu contains sub menus; General/IF, Data, Reed Solomon, ODU-BUC and
AUPC.
Transmit General / IF Menu
Figure 7-9. Transmit General | IF Menu
Network Spec: {CLOSED NET, DVB SAT}
Supports IDR and IBS Framing Modes in Closed Net
The Network Spec Command sets a number of parameters
within the modem to meet a set specification. The purpose is to
eliminate keystrokes and potential compatibility problems.
Additionally, data rates not covered by the given network
specification of operation will not be allowed. If the mode of
operation is selected after the data rate has been entered, then the
data rate must be compatible with the desired mode of operation
or the mode will not be allowed. The following parameters are
set and cannot be changed while the unit is in the given mode of
operation:
MN-DMD1050 7–14
Revision 9