Computer Weld Technology Micro ADM, Operation & Installation Manual

Page: 7 / 58

2.0 INSTALLATION
2.1 General Guidelines
The Micro ADM™ can be mounted two different ways. It can be installed at the
wire feeder using the quick disconnect fittings or mounted to a fixed surface.
Listed below are some things that should be taken into consideration when
selecting a place and method for mounting of the Micro ADM™:

Mount the Micro ADM™ in a location that is convenient for
installation of the welding wire and will not cause any binding
of the wire or the wire liner. It is recommended that the
Micro ADM™ be mounted as close to the wire feeder as
possible (
not to exceed 1 meter ).

The Positive welding cable must pass through the Micro
ADM™ sensor opening. Make sure that there is no stress on
the sensor as a result of movement of the welding cable.

The Shielding Gas line must be attached to the gas inlet of
the sensor. Consideration must be given to the routing of the
Shielding Gas hose to prevent any restriction of gas flow.

The Sensor cable must be mounted in such a manner as to
prevent stress on the sensor cable connector.

The two 18 gage conductors supplied with the Micro ADM™
are used to provide the + and – of the Voltage Sense. These
conductors must be routed so as not to produce stress on
the Voltage Sense terminal strip.

When mounting the Micro ADM™, position it so the operator
or maintenance personnel can see the sensor LEDs if
possible.

If using the optional mounting brackets to mount the Micro
ADM™, an insulating liner must be used for support of the
wire from the sensor to the back of the wire feeder inlet
guide.
3