TM
Details
Wiring Details
Data Harness (DR-HRN-2KDA Included In Box)
Green: (+) Ignition Input
- Connect this wire to the vehicle’s ignition output. This wire should see
(+) 12V when the vehicle’s key is in the “on” position. This wire is not required in Type 2 installations
unless the Drone compatible Data Controller requires it.
RS232 Plug
- This plug is intended to connect to the RS232 Data Port on CM5 or newer Firstech
compatible control modules. (Not compatible with LT Series) The control module must have the most
current firmware to be Type 2 compatible.
Type 1/3 Hardwire Harness (DR-HRN-2KHW)
Red: (+) 12 Volt Constant Input
- This is the constant power for the DR-2000. It carries a 2 amp fuse
and must be connected to the vehicle’s constant (+) 12 Volt source.
Green: (+) Ignition Input
- Connect this wire to the vehicle’s ignition output. This wire should see (+)
12V when the vehicle’s key is in the “on” position. This wire is required in Type 1 in order to program
the remotes.
Black: (-) Ground Input
- Connect this wire to the vehicle’s chassis ground.
Blue/Black: (-) Programmable Output 1
- This wire provides a programmable negative (-) output
that can be programmed on the Drone’s Option Menu. Please see the Special Option Group 2 Menu
for details. At the default setting this wire acts as a door lock output. This wire is not available in Type
2 installations. You must wire a relay to provide a positive (+) output.
7 | Copyright 2011 Firstech, LLC.
DR-2000 Install Guide
