Remote Programming Routine
IMPORTANT: Any and all remotes must be coded to the Drone prior to
performing any and all operations. Also the parking light output from the
Drone must be connected to indicate the programming sequence.
STEP 1:
Activate programming mode by manually turning the vehicle’s key
between the Ign On and Off (or the Acc & On positions) five times within
7 seconds. The vehicle’s parking lights will flash once with the successful
completion of this step. (Note: this step also places the Drone into Valet Mode)
STEP 2:
Within a 2 second period after the 5th ignition cycle tap Button I on two way remotes or
the Lock button on one-way remotes for a half second. The parking lights will flash once to confirm
the transmitter has been coded. Repeat for additional remotes, up to three.
Exiting Programming:
Programming is a timed sequence. After 2 seconds the parking lights will flash twice signaling the end
of programming mode.
Programming Multiple Remotes:
After the confirmation flash given in STEP 2, code additional
remotes by tapping Button I on two way remotes or the Lock button on one way remotes. The parking
lights will flash once confirming each additional remote. All systems can recognize up to three
remotes.
Note:
If you do not program any remotes and enter this sequence it will put the system into Valet
Mode. Only the keyless entry will work in Valet Mode. To exit Valet Mode just program remote(s).
Valet Mode
TM
11 | Copyright 2011 Firstech, LLC.
The DR-2000 has valet mode. This prevents the vehicle from remote starting and flashing any parking
lights. To exit valet mode tap the lock and trunk buttons on the remote, reprogram the remotes, -or-
uncheck the Valet option on the Web interface and click “Save.” If Valet is unchecked, check the box,
hit “Save” and then uncheck and hit “Save” again. These methods will take the DR-2000 out of Valet.
Programming
DR-2000 Install Guide
