TM
1-07
Timer Mode - This option enables the user to operate Timer Start (see option 1-04).
Remember that the user must still activate Timer mode using the remote (see the user
manual for that remote for instructions).
2-01
Factory Style Alarm - This option turns the Factory Style Alarm on or off. When this option is
combined with an interface module, it will monitor input triggers and will provide horn
output if programmed as one of the POCs. In Type 3 installations the Drone will only
monitor the Brown Wire.
2-02
Soft Disarm - When a vehicle has a factory alarm, and the Firstech alarm is triggered, you
may have both alarms triggered at the same time. In the default setting, silencing the
Firstech system will not send the disarm pulse to the factory system, therefore requiring the
user to first silence the Firstech system and then unlock and disarm to silence the factory
system. Setting 2 sends the disarm and 5 seconds later sends the rearm pulse.
2-03
Aux 1 Output - This option determines the duration of the auxiliary 1 output. Setting IV
allows the output duration to be set for a specific length of time.
2-04
Aux 2 Output - This option determines the duration of the auxiliary 2 output. Setting IV
allows the output duration to be set for a specific length of time.
2-05
Auxiliary Input (Brown Wire) - This option controls the input on the brown wire. At default
this wire will look for 5 ground pulses. The optional setting 2 looks for a constant ground
trigger and option 3 looks for a ground foot brake input. This is to shut the remote start
down in the event it is not covered by the bypass module.
2-06
Bypass Brand Through RS232 Port – Default setting allows for compatibility with ADS
Idatalink modules. Setting 2 changes compatibility to Fortin bypass modules.
17 | Copyright 2011 Firstech, LLC.
Programming
DR-2000 Install Guide
