CompuLab Tensor-I20, Owner'S Manual

Page: 8 / 58

www.fit-iot.com Page 8 of 58 Tensor-PC owner’s manual
Hayetsira St. 17, Yokneam, Israel
Tel: +972-48-290-168 | Fax: +972-48-325-251 | www.fit-iot.com
Tensor-PC hardware specifications
CPU Intel Xeon E-2276ML
Intel Core i7-9850HL
Intel Core i5-9300H
Intel Core i3-9100HL
Intel Celeron C4932E 6 Cores, 12 Threads, 12 MB cache, ECC support
6 Cores, 12 Threads, 9 MB cache 12 Threads, 9 MB cache
4 Cores, 8 Threads, 8 MB cache 8 Threads, 8 MB cache
4 Cores, 4 Threads, 6 MB cache, ECC support
2 Cores, 2 Threads, 2 MB cache, ECC support
Chipset Intel CM246 Chipset
RAM Up to 64 GB DDR4-2400
ECC | non-ECC 2x SODIMM DDR4-2400 ECC | Non-ECC (unbuffered)
Note: Buffered / registered RAM is not supported
Storage
NVMe M.2 2280 Up to 8 NVMe devices can be installed, each with PCIe 3 x4 interface
SATA M.2 Up to 2 SATA devices can be installed, (M.2 key-M 2280 | 2260 | 2242)
mSATA Up to 2 mSATA devices can be installed
SATA 2.5" Up to 2 2.5" SSD/HDD devices can be installed
Graphics &
display Integrated Intel UHD
Graphics P630 / 630 /
610 Up to 3x 4K displays
- DisplayPort 1.2 4096x2304 @ 60Hz
- HDMI 1.4 4096x2160 @ 30Hz
Specific types of ports depends on selected TELs.
Networking
Gbit Ethernet Using Intel i210, each port is on an independent PCIe port.
Using RJ45 ports. 20 ports can be installed.
Gbit Ethernet with PoE
source (PSE) POE+ 802.3at 30W per port.
Using Intel i210, each port is on an independent PCIe port.
Using RJ45 ports. 10 ports can be installed
4G/LTE modem Universal LTE cat 12 (Sierra EM7455) by default.
Other M.2 key-B or mini-PCIe modems can be installed.
Each modem-TEL has a SIM card tray optionally accessible from the outside.
Number of antennas as required by modems can be installed. Antennas can
be positioned anywhere on the computer's perimeter.
Up to 9 LTE modems can be installed.
Wi-Fi Wi-Fi 6 (Intel AX200) by default.
Buyer can install another Wi-Fi adapter.
Number of Wi-Fi antennas as required by Wi-Fi module. Antennas can be
positioned anywhere on the computer's perimeter.
Up to 9 Wi-Fi adapters can be installed.
Bluetooth Bluetooth 5.1 (Intel AX200) by default.
Bluetooth is normally an added feature in a Wi-Fi adapter. Buyer can
install another adapter.
Up to 9 adapters can be installed.
I/O
USB Up to 4x USB 3.1 gen 1
Over 40 ports of USB 2 can be installed
USB power in S5 can be configured per port
Audio 3.5mm jacks.
Headphones out + mic. in using TI PCM2912A Codec.
Multiple audio ports can be installed.
Serial ports
Using DB9 connector.
Each port supports RS232, RS485 half/full duplex and can be configured
independently.
Over 20 ports can be installed.
CANbus Using DB9 connector
Supports CAN 2.0A Specifications and ISO 11898-2
Bit rate of up to 1Mbit/s
DIP switch for enabling/disabling on-board 120 Ohm termination
Isolation per UL 1577, transient immunity: 30kV/uS, isolated DC 5V power
CANbus is driven by a dedicated 32bit microcontroller (ARM Cortex M0 -
STM32F042C6) running open source firmware that can be upgraded
Driverless operation in Windows
USB native device in Linux
Over 10 ports can be installed
GPIOs Unidirectional Isolation block, isolation per UL 1577
GPIOs are driven by a dedicated 32bit microcontroller (ARM Cortex M0 -
STM32F072CB) running open source firmware that can be upgraded
Each GPIO can be configured as input/output in software
Terminal block connector
3.3V / 5V level can be selected by a DIP switch
Over 100 GPIO ports can be installed