NOTE:
Standard motors are open drip proof with a maximum ambient temperature rating of
104 degrees F. They are not suitable for salt laden, corrosive, dirty, wet, or explosive environments.
IMPORTANT:
If voltage supplied to the compressor is below 208 volts the unit need a 200 Volt drive
motor and 208-230-460 Volt should not be used below 208 volts.
CAUTION
CAUTION
!
Under no circumstances should a compressor be placed in an area that
may be exposed to a flammable, toxic, volatile or corrosive atmosphere
nor should flammable, toxic, volatile or corrosive agents be stored near
the compressor.
CAUTION
CAUTION
!
Improper lifting can result in component or system damage or
personal injury.
Follow good shop practices and safety procedures
Receiving and Uncrating of your Compressor
BEFORE UNCRATING THE COMPRESSOR THE FOLLOWING STEPS SHOULD BE TAKEN.
1. Immediately upon receipt of the equipment, it should be inspected for damage that may have occurred during
shipment. If any damage is found, demand an inspection immediately by an inspector from the carrier. Ask him/
her how to file a claim for damages. (Never attempt to move compressor without proper lifting equipment).
2. Insure that adequate lifting equipment is available for moving the machinery.
3. Read the compressor nameplate to be sure the compressor is the model and size ordered.
4. Read the motor nameplate to be sure the motor is compatible with your electrical conditions.
(Volts-Phase-Hertz).
Compressed Air Systems, LLC 1-800-531-9656 Fax 972-352-6364 www.compressed-air-systems.com
5-15 HP Electric Rotary Screw Compressors