Page 6
2) RS232(DB9): Connect to a PC or control system with D-Sub 9-pin
cable for the transmission of RS-232 commands.
Note: The RS-232 interface can control the machine.
3) IR IN: Connect with the supplied wideband IR RX
4) RS232(3.81mm 3P captive screw connector):Connect to a PC or
control system with a D-Sub 9pin to 3P cable.
Note: The RS-232 interface only with the remote receiver
(HDBaseT Receiver) RS-232 communication.
Part5: UPDATE PORT
Connect U flash drive, system software update.
Part6: DC POWER INPUT
Plug the 24V/1A DC power supply into the DC24V power in.
6. Remote Control
1. Press this button to power on the
switcher or set it to standby mode.
2. Input Selection: Press these buttons to
switch to the required source.
3. Audio select: Click these buttons to
select audio from digital (INT) or analog
(EXT), when the signal is switch to the
HDMI or DVI signal source.
4. Press scaler or auto adjust button to
adjust the output picture.
Note: a. When the signal source for
VGA(RGBHV) input, auto adjust button is
valid.
b. Scaler adjust the step: six steps.
5. Resolution select: Press these buttons
to select different resolution output.
6. These buttons for function extension
keys.
