3
ST
6.
OPERATION CONTROLS AND FUNCTIONS
6.1
Transmitter's Front Panel
STD/HQ:
This switch allows user to select which compression mode
to use when AVLC is active. HQ (High Quality) mode uses the
least amount of compression and provides the highest possible
visual quality (perceptually identical to the original). STD (Standard
Quality) mode applies additional signal reduction methods to
lower the bandwidth requirements of 4K sources further, improving
transmission reliability over longer cable runs at the cost of some
visual fidelity.
ISP:
This button is reserved for factory use only.
STD/UPDATE:
This switch is reserved for factory use only. The default
setting is “STD”.
RS-232 IN:
Connect to a PC, laptop or other serial control device
for the extension of RS-232 signals.
LAN:
Connect to an Ethernet supporting device or to your local
network, as appropriate, to extend the network to both ends of
the HDBaseT connection.
SYNC LED:
This LED will illuminate when a live input source is
detected.
HQ/STD LED:
This LED will illuminate whenever the AVLC function
is active. A green LED indicates that AVLC is in HQ (High Quality)
mode. A red LED indicates that AVLC is in STD (Standard) mode.
POWER LED:
This LED will illuminate to indicate the unit is on and
receiving power.
LINK LED:
This LED will illuminate solidly when a live connection with
a compatible Receiver is active. The LED will blink with a regular
pattern if a Receiver is connected but there is not currently a live
signal. The LED will blink with an irregular pattern if a connection
error has occurred.
LAN
