![Compaq 7470 - Presario - 64 MB RAM Maintenance And Service Manual Download Page 153](http://html1.mh-extra.com/html/compaq/7470-presario-64-mb-ram/7470-presario-64-mb-ram_maintenance-and-service-manual_2645498153.webp)
not
detected.
Incorrect driver is
installed.
Ensure the correct driver is installed in
CONFIG.SYS.
Drive has been changed.
Make sure the jumper setting is set for "Slave."
Proper drivers are not
loaded.
Restart the system and make sure the DVD
drive drivers are loaded.
Resolving Hardware Conflicts
Hardware conflicts occur when two or more peripheral devices attempt to use the same hardware
resources. I/O addresses, interrupts, and DMA channels are the most common hardware resources
used by peripheral devices. For example, the factory default settings for the MIDI port audio
interface are:
Base I/O address
220H
MIDI Port Base I/O address
330H
Interrupt
IRQ 5
8-bit DMA
Channel 1
When different peripheral devices use the same hardware resources at the same time, the devices
and/or the system may not function properly. You can resolve hardware conflicts by ensuring that
no devices are configured to use the same hardware resources. These resources can either be
dipswitch or jumper settings on the peripheral card or software configurable resources. The
Computer Setup selection of your Compaq Utilities allows you to view and modify the settings for
the peripheral devices factory installed in your system. Refer to the
User's Guide
for the particular
peripheral cards you wish to install for information on how to view and select their settings.
To resolve hardware conflicts:
1 Change the hardware settings of your audio card or other peripheral card in your
system if the peripheral card is using any settings used by the factory-installed
devices.
2 If you are unsure of the settings of the peripheral cards, you can isolate the
source of the problem by temporarily removing all cards not manufactured by
Compaq, or resetting the default settings and running Compaq Utilities. After
that, add the cards back one at a time until the card that is causing the conflict is
found.
Also see:
Compaq.com - Compaq Presario Maintenance and Service Guide - 7400 Series
http://www.compaq.com/athome/support/msgs/7400/trbnod1.html (5 of 6) [1/8/2002 3:52:59 PM]