Green power
light is
flashing.
Your flat-panel
monitor does not
support the video
resolution or refresh
rate.
FP400 and FP500 Series flat-panel monitors only
support 1024 x 768 resolution mode. Connect a VGA
monitor temporarily and change your resolution
setting in the
Display
dialog box:
1
Click on
Start
2
Point at
Settings
and click on
Control Panel
3
Double-click on
Display
4
Click on the
Setting
tab, and move the sliding
pointer to give 1024 x 768 pixel resolution.
CD drive
Problem
Probable
cause(s)
Possible solution
Cannot read
compact disc.
CD is not properly
seated in the drive.
Eject the CD, then re-insert it, pressing down
gently on the CD to correctly seat it in the
drive.
CD has been loaded
upside down.
Eject the CD, turn it over, then reload.
CD may be dirty or
scratched.
Clean the CD or load another CD.
Cannot eject
compact disc
(tray-load
only).
CD is not properly
seated in the drive.
Turn off the computer, insert a straightened
paper clip into the emergency eject hole, then
push firmly. Slowly pull the tray out from the
drive until the tray is fully extended, then
remove the CD.
CD drive devices
are not
detected.
Power cycle delay
After turning the computer off, wait 30
seconds before turning the computer on again.
Compaq.com - Compaq Presario Maintenance and Service Guide - 7400 Series
http://www.compaq.com/athome/support/msgs/7400/trbnod1.html (3 of 6) [1/8/2002 3:52:59 PM]
