4-12
Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer:
Jennifer Hayward
Project:
Compaq ProLiant ML330 Generation 2 Server Setup and Installation Guide
Comments:
Part Number:
234833-001
File Name:
e-ch4 Cabling Guidelines.doc
Last Saved On:
5/22/01 2:42 PM
Cabling ATA Devices
The following steps detail the procedure for connecting cables from an
integrated ATA/100 controller to an internal ATA hard drive or other device:
1.
Install the device. Refer to “Installing a Hard Drive” or “Installing a
Device into a Removable Media Bay,” in Chapter 3, “Hardware Options
Installation,” for instructions.
2.
Make sure that the jumper on the drive is set to Cable Select (CS).
3.
Install the next available cable connector to the hard drive or ATA
device. Figure 4-9 and Table 4-4 show the cabling configuration when
four ATA hard drives are installed. If fewer than four drives are
installed, then follow these cabling steps accordingly.
2
4
1
3
Figure 4-9. Cabling an ATA hard drive or other device
Table 4-4
ATA Cabling Sequence
Step
Channel/Cable
Cable Connector
Drive Location
Primary
Device 0
Hard drive bay 2
Secondary
Device 0
Media bay 3
Primary
Device 1
Hard drive bay 3
Secondary
Device 1
Media bay 4
Note:
Refer to Chapter 1, “Server Features,” for drive bay locations.
