INS_NW7[E]/M_REV– 06/10/13 PAGE 19
INSTALLATION AND OPERATION MANUAL
NW7[E]/M
TECH SUPPORT: 1.888.678.9427
9.5 Associated Stations (for AP Mode)
This section shows the connected devices, if the Radio is in the AP mode.
Figure 7: List of Associated Stations.
If there are no associated Clients, the text “No information available” is displayed. The parameters
shown are as follows:
MAC-Address Displays the MAC address of the station's radio.
Network
States the name of the wireless network.
Device Name Shows the name of the station.
Last IP
States the most recent IP address of the station as seen by the Radio.
Signal
Displays the received signal strength from the Client e.g. -26 dBm.
Signal/Chains Shows the received signal strengths from the station on each antenna e.g. -42, -26 dBm. The
value of -95 dBm is taken to mean “no antenna” if the radio has only 2 antennas.
Noise
Displays the received noise power at the AP.
TX Rate
Shows the transmit bit rate from the AP towards this Client.
RX Rate
Shows the receive bit rate at the AP from this Client.
TX-CCQ
Indicates the wireless connection quality.
9.6 System
This section shows the Netwave Product name, Firmware Version, Kernel Version, and Local Time.
Figure 8: System parameters.
9.7 Memory
Here, the Total Available and Free memory are shown.
Figure 9: Total Available and Free Memory.
