6
3.2.2 Get correction message from Radio or Ntrip
3.2.2.1 Internal Radio setup
This step is for setting up internal UHF frequency and protocol. You must
link
DC3 port to set
radio parameters. Go to
in shortcut bar, set up the Frequency and protocol (same as
external transmit radio).
3.2.2.1 Get correction message from Ntrip
Make sure your laptop or PC can use internet.
Go to
, there are two protocols to receive the correction data: internet-TCP direct and
Ntrip mode. If the protocol is TCP direct mode, input the IP address and port and click
Connect
;
If using the Ntrip mode, tick the
Ntrip
mode then click
Connect
.
Tips:
The internal radio airlink rate is 9600bps, and the radio is linked to com2 of GNSS
board as the baud rate of 115200bps. So you must set the airlink baud date of transmit
radio as 9600 bps, and the com2 baud rate of GNSS board as 115200 bps (the default band
rate is 115200).
