COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Setup And Operating Procedures

Page: 17 / 30

- 17 -
NOTE: Third party needs to be aware of basic radio etiquette and delays for radio keying
Otherwise, they will monopolize the radio channel or will not be properly understood by the radio
users.
To remove the connector for cable storage, push inward on the locking ring and turn the ring counter
clockwise to release the locking mechanism. Then pull the connector straight out of the jack. Hold
the chrome barrel of the connector rather than the cable.
Nextel
TM
phone in DirectConnect
TM
mode
When connecting a Nextel
TM
connect the phone as you would an L-M-R.
Install the radio-end of the ICRI interconnect cable onto the accessory jack at the bottom of the
phone, as you would install any accessory (i.e.: a shoulder speaker / microphone)
Attach the other end of the cable to any of the LAND MOBILE RADIO INTERFACE jacks.
NOTE: The Nextel speaker and mic will be disabled while the phone is connected to the ICRI.
The local handset
This handset can be used as a local incident command radio or a troubleshooting device. Up to 250’
of cable maybe added to the cable length. Then handset maybe replace with a C-AT provided
headset.
The handset microphone is enabled when the push-to-talk bar in the center of the handset is
depressed and held down.
The audio level to the handset speaker can be adjusted by the rotating the volume knob above the
jack. Counterclockwise decreases the audio level, and clockwise increases the listening level.