COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Setup And Operating Procedures

Page: 10 / 30

- 10 -
RADIO JACK (1 thru 5) J
The five radio interface jacks on this unit are a 5-pin, U183 locking jacks. All radio jacks are
compatible with a military and commercial radios and Nextel
™
Direct Connect
™
phones (except
Blackberry and i60/i90 models)
Pinout:
1- Ground
2- Audio from radio
3- Audio to radio
4- Motorola® Saber/AstroSaber P-T-T enable
5- P-T-T Enable (except Motorola Saber and Motorola P Series Radios)
TELEPHONE /ACOUSTIC COUPLER JACK: K
This interface jack can be used to connect the ICRI to a satellite telephone, land-line or cellular
phone. The 8-pin locking-type jack supports the connection of the ICRI to a telephone through the
acoustic coupler (PN 1790.650) or the 2.5mm jack on a cell phone (PN 179.0672)
Pinout:
A- Audio TO telephone (acoustic coupler)
B- Audio FROM telephone (acoustic coupler)
C- Audio TO telephone (acoustic coupler)
D- Audio FROM telephone (acoustic coupler)
E- Ground
F- Required jumper
G- Audio TO telephone (2.5mm plug)
H- Audio FROM telephone (2.5mm plug)
POWER (DC INPUT) JACK: L
Power jack is used to connect ICRI battery pack, alternative DC power source (vehicle) or AC
power. The Power jack is an 2-pin locking jack. Align arrow at top of ICRI to properly insert the
power jack. To remove, unscrew the connector and then gently pull on the connector at the base.
Pinout:
1 – +7 to +20 VDC
2 – Ground