CommScope Teletilt ATC200-LITE-USB, Installation And Operation User Manual

Page: 4 / 150

ATC200-LITE-USB Teletilt
®
RET System
ii
October
2014 Bulletin 639536 • Revision L
SAFETY NOTICE
The installation, maintenance, or removal of an antenna
requires qualified, experienced personnel. Andrew
installation instructions are written for such installation
personnel. Antenna systems should be inspected once
a year by qualified personnel to verify proper installation,
maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the results
of improper or unsafe installation practices.
Installation Training Available at Andrew Institute
Do not install near power lines.
Power lines, telephone lines,
and guy wires look the same.
Assume any wire or line can
electrocute you. Do not install on a wet or
windy day or when
lightning or thunder is
in the area. Do not use
metal ladder. Wear shoes with rubber soles
and heels. Wear protective
clothing including a
long-sleeved shirt and rubber
gloves.
IMPORTANT
Before installing/operating the ATC200-LITE-
U S B c o n t r o l l e r, p l e a s e
D O W N L O A D t h e
latest antenna definition file and controller
software
from the Commscope web site at
www.commscope.com. Please register online to
receive E-mail notifications for software updates.
WARRANTY NOTICE
Proper installation procedures must be followed when
installing and operating RET equipment. Failure to assure
installations are done properly by trained installation
personnel and to follow procedures discussed in this bulletin
may cause warranty for such products to be void.
Andrew requires that all RET installations be pre-tested
and configured prior to installation. Failure to conduct pre-
test and pre-installation procedures defined by Andrew will
void warranty.
Notices and Precautions