ADCP-93-090 • Rev C • March 2021 • Preface
Page iii
© 2021, CommScope, Inc.
ABOUT THIS MANUAL
This manual contains OMX Splice Bay component descriptions, installation instructions, and
cable routing procedures (including overhead and raised floor cable routing environments) for
both the standard and lockable splice tray doors versions.This manual contains OMX Splice
Bay component descriptions, installation instructions, and cable routing procedures (including
overhead and raised floor cable routing environments) for both the standard and lockable splice
tray doors versions.
RELATED PUBLICATIONS
Listed below are related manuals and their publication numbers. Copies of these publications
can be ordered by contacting the CommScope Technical Assistance Center at
http://www.commscope.com/SupportCenter
Round Splice Tray Cable Routing Instructions
90-321
ADMONISHMENTS
Important safety admonishments are used throughout this manual to warn of possible hazards to
persons or equipment. An admonishment identifies a possible hazard and then explains what
may happen if the hazard is not avoided. The admonishments — in the form of Dangers,
Warnings, and Cautions — must be followed at all times. These warnings are flagged by use of
the triangular alert icon (seen below) and are listed in descending order of severity of injury or
damage and likelihood of occurrence.
GENERAL SAFETY PRECAUTIONS
Title/Description
ADCP Number
Danger:
Danger is used to indicate the presence of a hazard that
will
cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Warning:
Warning is used to indicate the presence of a hazard that
can
cause severe personal
injury, death, or substantial property damage if the hazard is not avoided.
Caution:
Caution is used to indicate the presence of a hazard that
will
or
can
cause minor
personal injury or property damage if the hazard is not avoided.
Warning:
Never install communication equipment in a wet location or during a lightning
storm. When installing or modifying communication lines, disconnect lines on the network side
before working with uninsulated wires or terminals.
Summary of Contents for OMX 600 Splice Bay
Page 6: ...ADCP 93 090 Rev C March 2021 Preface Page 2 2021 CommScope Inc TABLE OF CONTENTS Content Page ...
Page 41: ...ADCP 93 090 Rev C March 2021 Page 35 2021 CommScope Inc Figure 36 OSP Breakout Assembles ...
Page 43: ...ADCP 93 090 Rev C March 2021 Page 37 2021 CommScope Inc Figure 38 IFC Breakout Assemblies ...