ADCP-92-098 • Rev C • May 2018
Page 18
© 2018
CommScope
. All Rights Reserved.
Figure 18
shows routing from the left side.
Figure 18. Routing Pigtails from Left Side (Top View)
4.1.2
Routing OSP Cable, Right Side Entry
For right side cable entry, route the OSP cable from the cable clamp position to the splice tray as
shown in
Figure 19
. Note that “right” is defined here from the perspective of the front of the
panel.
24627-A
SLACK LOOP AROUND OUTSIDE OF
SPLICE TRAY IS NOT REQUIRED
NOTE:
STUB
END
CORRECT LENGTH AT ADAPTER PACK
IF NECESSARY, PULL EACH 900 MICRON FIBER FROM
STUB END OF SUBUNIT, TO CORRECT LENGTH TO
ELIMINATE SLACK AT ADAPTER PACK.
RECOMMENDED CABLE
LENGTH FROM STUB END
TO CONNECTOR IS 108 INCHES
