4
5.3 Fix the strength member underneath the metal screw
as shown in
Step
5.4
. Tighten the screw to secure the
strength member. Cut the excess off.
5.4 Fit the cable onto the designated cable port and
make sure the blocking ring is in the slot, as shown.
5.5 Screw tight the upper clamps
Note:
After slightly tighten the first screw, firmly
tighten the second screw. Then, firmly tighten the first
screw.
Note:
leave 10mm from the clamp end to the tip end
for each cable, as shown below.
5.6 Secure cables with tie wraps, as shown. Cut the
excess off.
6 Fiber
preparation
6.1 Loop the pass-through cable slack, as shown.
Note:
Use Port 1, Port 4 for one loop cable
Use Port 2, Port 3 for second loop cable
10mm
1 2
3 4
