3
4.4 Take out upper clamp and the dummy rods.
4.5 Separate the dummy rod and the blocking ring, as
shown
4.6 According to the cable range choose the appropriate
side of the cable clamp and remove the white sleeve
layer installed on the lower clamp if necessary (refer
to Table 1).
Cable
range
(mm)
Cable
clamp
White snap
block
Blocking
ring
8-9.3 Small Yes
Yes
9.3-12 Small Remove Remove
12-14 Large Remove Remove
Table 1, Cable clamp selection
Clamp type
White snap block
5 Cable
Installation
5.1 Make a window cut of 1500mm and cut the strength
member up to 50mm from the cable jacket end.
Note:
If the cable has jacket covered on strength
member, Please remove the jacket before
installation.
5.2 Clean the cable sheath, where it contacts gel, with
cleaning tissue provided.
50mm
1500mm
Large
Small
