ADCP-90-326 • Rev B • November 2020
Page 23
© 2020, CommScope Inc.
7 OPERATION
The term “operation” refers to procedures performed on an ongoing basis after the FMT is
installed. The only FMT trays that require operation are those having a termination function.
Patch cords may be installed in such trays for use in connecting or testing equipment. When
routing patch cords, refer to the routing diagrams provided in
Section 6 Installing and Routing
. For instructions on accessing adapters, refer to the following instructions.
7.1
Opening Tray
To open the FMT tray, slide the release tabs inward with both hands and pull the drawer straight
out as far as it goes. The latch locks the tray in the open position as shown in
.
Figure 20. Tray Locked in Open Position
Caution:
Placing a load in excess of 5 pounds (2.3 kg) onto an open tray will result in
misalignment or damage to the tray.
20204-A
PRESS TO
RELEASE
RELEASE
TAB
RELEASE
TAB
