CommScope ADCP-90-326, User Manual

Page: 19 / 26

ADCP-90-326 • Rev B • November 2020
Page 19
© 2020, CommScope Inc.
6.6 12-Position Termination and Splice Tray
Termination and splice trays provide 12 termination and splice positions. Install the cables for a
12-position termination and splice tray as follows:
1. Break out the cable corresponding to the dimensions provided in Figure 15 .
2. Route the cables into the tray as shown in Figure 16 , and perform the splices outside the
tray at an adjacent work area, as shown. Perform the splices following local practice.
Refer to pigtail installation drawing (provided with FMT) for pigtail connection scheme.
3. Loop the cables three times around the radius limiters as shown in Figure 17 .
Figure 15. 12-Position Termination and Splice Tray Breakout Dimensions
4. Carefully position the tray within the splice area as shown in Figure 18 . Make certain that
the pre-terminated and customer fiber bundles are properly routed around the appropriate
radius limiters as they enter the FMT (see
Figure 18 ).
5. Use the kurly locks provided to bundle fibers together as needed. Place kurly locks at
locations indicated in Figure 19 .
6. Verify that the completed tray looks as shown (see Figure 19 ).
Note: Splicing instructions are not included. For splicing instructions, follow local practice.
Note: Tie off the cable at the tie off point shown in Figure 17 , using a one-inch section of
soft wall jacket per the breakout dimensions shown in Figure 15 .
48 IN. (121.9 CM) 1 IN. (2.5 CM)
16967-A
133 IN. (337.8 CM)
SOFT WALL
PIGTAIL BUNDLE
SECTION OF
SOFT WALL
JACKET
900 MICRON
JACKETED
FIBERS