5 HOMEDEPOT.com
Please contact 1-877-527-0313 for further assistance.
Installation
1
Preparing the exit light
□
Remove the faceplate (A) using a flat screwdriver.
□
Remove the appropriate arrow(s) (1) to indicate
the direction of the exit.
□
For double-sided applications, remove the
backplate (C) using a screwdriver and replace
it with the second faceplate (A). Double-sided
applications can only be used with a ceiling or
end mount.
□
Plug in the back-up battery by connecting the
battery lead to the PCB board.
A
1
2
Changing the color (optional)
□
Remove the placard buttons (1) by twisting
them back and forth while pulling up. Remove
the preinstalled red lens.
□
Insert the green lens (E) and replace the placard
buttons by pressing them into place.
□
Move the color selection switch to the “G”
position.
D/E
1
3
Installing the exit sign on a
ceiling or end mount
NOTE:
For wall mount applications proceed to Step 4.
□
Remove the top/side mount access caps (H) by
pushing up and out from the underside.
□
Pull the power supply wires from the junction box
through the center hole of the JBOX mounting plate
(F). Attach the JBOX mounting plate (F) to the junction
box using the junction box screws (not included).
□
Feed the fixture wires through the appropriate top or
side mounting hole and through the canopy nose.
□
Insert the canopy nose into the mounting hole on the
exit sign frame (B) and lock it into place by rotating
the canopy 90º and sliding to the right, into the
locking flange, until it locks into place
□
Connect the wiring. Refer to “5 Connecting the
wiring”. Feed the wire nuts back through the center
hole of the JBOX mounting plate (F) into the junction
box.
□
Thread the screws (AA) through the screw holes in
the canopy (G) and attach the canopy to the JBOX
mounting plate (F).
H
AA
G
B
F
H
