ENGLISH
Page 13
SET UP & USE
INSTALL R1 HARDWARE
In order to minimize air leaks and ensure
optimal insulation, it is necessary to install
the included R1 hardware to the side
curtain. Follow the instructions below.
Step 1. After the unit is installed to the
window, measure the inner width of
the side curtain as shown (Fig.11).
Step 2. Remark a line on the provide R1
insulation panel according to a
length 1/8 (3mm) less than the
measured width in step 1, then cut
the R1 insulation panel along the
line (Fig.12).
Step 3. Slide the R1 insulation panel into the
side curtain, the side with pattern
should facing the indoor side.
(Fig.13).
Step 4. Repeat on the other side.
INSTALL WEATHER STRIPPING
(only be applicable to Energy star models)
In order to minimize air leaks between
the room air conditioner and the window
opening, trim the weather stripping with
a proper length, peel off the protective
backing and plug any gaps if needed
(Fig.14).
IF AC IS BLOCKED BY STORM
WINDOW
Add wood as shown in Fig.15 or remove
storm window before air conditioner is
installed. If Storm Window Frame must
remain, be sure the drain holes or slots are
not caulked or painted shut. Accumulated
Rain Water or Condensation must be
allowed to drain out.
REMOVING AC FROM WINDOW
Turn AC off and disconnect power cord.
Remove sash seal from between windows
and unscrew safety sash lock. Remove
screws installed through frame and frame
lock. Remove the R1 Panel and close
(slide) side panels into frame. Keeping a
firm grip on air conditioner, raise sash and
carefully remove. Be carefully not to spill
any remaining water while lifting unit from
window. Store parts WITH air conditioner.
Fig. 11
Fig. 12
Fig. 13
Fig. 15
Fig. 14