Command Light KNIGHT KL415A, Manual

Page: 16 / 41

KNIGHT
2
16
Warning Device Installation
Tools Required:
•
3
/
32
” Flathead Screwdriver
• Wire Strippers
• Small Torch or Lighter
Wire the gray 22-20 control cable wires to the small connectors using the wiring schematics provided.
There are 2 different schematics, one is the standard version and the other is the version for dual control
with wireless controllers or V-Mux control. The standard schematic will be used for V-Mux or any other
multiplex system if it is only being used for elevated warning. A V-Mux wiring schematic and circuit
board troubleshooting guide are included.
Detaching & Attaching the Controller
1. Loosen the
small nut.
2. Loosen the
large nut.
3. Gently slide the
connector away
from the holster.
4. Disconnect the
cable by pressing
down on the tab
and pulling.
Make sure the tab on the ethernet (CAT 5) connector is in the slot before attaching the cord. Lock the
large nut, make sure the ethernet cord is pushed all the way in, lastly tighten the small nut onto the cord.