Command Light KNIGHT KL415A, Manual

Page: 15 / 41

USER GUIDE
15
Electrical Wiring
Please Note : Detailed internal wiring schematics are located at the back of this user guide.
Run the control wire from the control box holster to the KNIGHT
2
.
Run the power wire from the breaker box or generator to the KNIGHT
2
. A 20 Amp breaker is
recommended on AC models with LED fixtures.
Make the control connections in the KNIGHT
2
relay box.
The standard model KL415A series KNIGHT
2
comes pre-wired to connect to 120 VAC. It is necessary
to remove the jumper connecting the red and black terminals for 240 VAC operation.
Holster Wiring
Determine if an elevated warning device will be used in conjunction with the light tower. If a warning
device will be used, use the wiring diagram on the next page, otherwise, use the wiring diagram in the
back of the user guide.
After routing the control cable into the holster through the sealing connector, attach individual wires to
the provided connectors and insert the connectors into the proper ports on the circuit board.
120 VAC
240 VAC
If 240 VAC operation is desired, remove the
jumper wire between the red and black leads.
220 VAC European
If the light tower is ordered with 220 VAC (Single
Hot Leg) wiring, only use a single hot conductor
from the power source, the other is not needed.