Command Light CL602D, User Manual

Page: 14 / 46

COMMAND LIGHT
13
Electrical Wiring
Please Note: Detailed internal wiring schematic for the light is found in the supplement pages found at
the end of this document.
Run the control wire from the control box holster to the COMMAND LIGHT .
Run the power wire from the breaker box or generator to the COMMAND LIGHT . A 100 Amp breaker
is recommended on DC models.
Make the control connections in the COMMAND LIGHT entrance box. To simplify installation remove
the connector hold down screws and pull the connector out of the box slightly.
The Model CL602D series COMMAND LIGHT comes pre-wired to connect to 12 VDC.
Holster Wiring
Determine if an elevated warning device will be used in conjunction with the light tower. If a warning
device will be used, use the wiring diagram on the next page, otherwise, use the wiring diagram in the
back of the user guide.
After routing the control cable into the holster through the sealing connector, attach individual wires to
the provided connectors and insert the connectors into the proper ports on the circuit board.
12 VDC Wiring Diagram