ATTACH THE WH11 or WH32 TO THE WALL
Attach the WH11 or WH32 at the equipment to a wooden
surface as shown using the screws and wall anchors supplied.
Install an R80CJ damper in the duct supplying air to the upstairs
bedroom area and plug one end of the cable into the connector
marked IN on the Actuator and the other end into the connector
marked SLEEPING DAMPER on the Wiring Hub. Install a second
R80CJ damper in the duct supplying air to the downstairs living
area and plug one end of the cable into the connector on the
Actuator marked IN and the other end into the connector on the
Wiring Hub marked LIVING DAMPER. Each damper uses 2.4VA
of power.
When two or more dampers are required to define the upstairs or
downstairs areas, the second damper may be plugged into the
connector marked OUT on the first damper. LEDS on the damper
actuator indicate when the damper is fully open (green) or fully
closed (red).
INSTALL UPSTAIRS & DOWNSTAIRS DAMPERS
Ensure that damper installation does not cause
obstruction to the damper blade.
WIRING INSTRUCTIONS
Wiring Thermostat to WH11 or WH32 Wiring Hub
Use 5-conductor(1 spare), 18 or 20 gage, thermostat cable to
wire the WH11 or WH32 Wiring Hub to a C365C42 or
C365C42WF Communicating Thermostat.
C365
Terminal
5V
GND
SA
SB
Wire Color
Red
White
Blue
Yellow
Wiring Hub
Terminal
5V
GND
SA
SB
Function
24VAC Power
Common
Signal A
Signal B
!
Green LED
Red LED
4-5/16 inches
+5V
GND
SB
WIRING HUB
SA
Thermostat Model C365C42 or C365C42WF
Existing thermostat cable
in replacement installations.
Wiring Diagram
C365C42
Wiring Hub Model WH11 or WH32
Warning - Only use plug and play cable provided
with the A80MJ actuator. Additional cables can be
ordered through eControls, Model #PIC25 (25 ft.).
!
R
C
W/B
O
Y
G
W2/E
Y2
SLP
SLP
SENSORS
TSTAT
HVAC
ODT
ODT
GND
+5V
SA
SB
LIVING SLEEP
SPACE SPACE
DMPR
DMPR
INSTALLER
Warning!
!
Turn the power to the HVAC equipment off before wiring.
