CAUTIONS
Use cautions when mounting components to surfaces
that may have concealed wiring beneath the surface.
!
INSTALLATION
Before installing the Comfort365 system, turn off
all power to your HVAC system.
Read and follow all instructions carefully.
Follow all local electrical codes during installation. All
wiring must conform to local and national electrical
codes.
i
ATTENTION INSTALLER
Nighttime Airflow Control is defaulted to ON. If
bedrooms are located downstairs, consider turning this
option Off using the User Options if bedrooms are not
on the same trunk.
Airflow Control is defaulted to On and controlled by
Options 50 thru 53.
Install and wire components to the wiring hub.
Airflow Control Off Option 50 turns off Airflow Control
and the thermostat operates as a typical thermostat.
The thermostat controls the system, dampers fully open,
nighttime airflow control is disabled and airflow is no
longer displayed on the thermostat.
User Airflow Control (Manual Airflow Control) can be
enabled in the User Options. Go to Menu Option #2
and turn off automatic airflow control.
Read entire manual before installing products.
When servicing Comfort365 system or accessing
products, turn off all power to these items.
Place the thermostat on the subbase. Do not install
batteries. (See C365C42 or C365C42WF manual).
Turn power to the HVAC equipment On.
Check for Start Up Messages/Errors.
Set equipment options 1-6 if different than factory
default settings. (see C365C42 or C365C42WF
manual).
1)
3)
If wireless sensors are used, install the ELR1 plug in
radio module in the wiring hub and set the sensor
number and home number as necessary.
2)
4)
5)
6)
Test the installation by initiating a heating call, cooling
call and fan call.
7)
Install batteries and set the time and day (see
C365C42 or C365C42WF manual).
8)
i
Homes with plaster walls with steel lathe may
experience wireless communication interference
when using wireless sensors. Wired sensors are
recommended under those conditions.
INSTALLER
Refer to C365C42 or C365C42WF manuals for accessing:
