21
104570
OWNER’S MANUAL
FIREPLACE
INSTALLATION
Continued
WIRELESS HAND-HELD
REMOTE CONTROL - GHRC
Installing Battery into Receiver
1.
Open bottom louver and locate the
switch bracket on the left.
2.
Unscrew the switch bracket. Lean
bracket forward so you are able to ac-
cess the back of the remote receiver.
3.
Locate the battery clip mounted on the
back of the receiver. Slide a 9-volt bat-
tery (not included) through the clip.
4.
Attach the terminal wires to the battery.
5.
Replace the switch bracket.
Figure 40- Attaching Battery to Receiver
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1.
Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to a 9-volt bat-
tery (not included). Place battery into
the battery housing.
3.
Replace battery cover onto remote con-
trol unit.
Figure 41 - Installing Battery in Hand-
Held Remote Control Unit
Battery
Cover
9-Volt
Battery
Terminal
Wires
Remote
Control Unit
Battery
Housing
9-Volt Battery
Receiver
Terminal
Wires
Battery Clip
REMOVING/REPLACING
SCREEN AND GLASS DOOR
CAUTION: Do not operate this
fireplace with a broken glass door
panel or screen. Do not operate
this fireplace without the glass
door panel and screen securely
in place. For replacement part
information see
Replacement
Parts, page 31.
1.
Remove the upper louver panel by lift-
ing upward and out (see Figure 42).
2.
Slide screen upward out of lower brack-
ets. Rotate screen toward you so that
screen clips rotate out away from fire-
box. Slide screen out of clips. See Fig-
ure 43, page 22.
3.
Remove the screws from the three tabs
at the top of the glass door while hold-
ing door securely keeping it from fall-
ing forward.
4.
Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 44, page 22).
5.
To replace glass door and screen, fol-
low the above instructions in reverse.
You must remove screen and glass door to
install optional brick liners, logs, lava rock,
and ember material.
Figure 42 - Removing Top Louver Panel
Top Louver
Panel
Continued
