For more information, visit Comfortflame.US.com
PFS
®
US
Installation and Operation Instructions
Comfort Flame
®
Unvented (Vent-Free)
Gas Stove Appliance Models:
NCBurnerZMN
NCBurnerZMP
Remote-Ready Control Gas Log Appliance
(Burner System for Cast Iron stove)
P/N 900577-00 Rev NC 02/2016
Report No. 09-128
P900577-00
IMPORTANT: This burner system must be installed
into approved IHP cast iron stove body, model:
Newcastle (F2510) only.
WELCOME HOME TO WARMTH
®
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This appliance may be installed in an aftermarket permanently located, manufactured (mobile) home, where not
prohibited by local codes. This appliance is only for use with the type of gas indicated on the rating plate. This
appliance is not convertible for use with other gases.
This is an un-vented gas-fired appliance. It uses air (oxygen) from the room in which it is installed.
Provisions for adequate combustion and ventilation air must be provided. Refer to Air for Combustion and
Ventilation section on page 5 of this manual.
WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
WARNING:
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could result in serious injury, death, or property damage.
—
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
—
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Leave the building immediately.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
—
Installation and service must be performed by a qualified installer, service agency or the gas
supplier.