Comeup CWL-301L, Instruction Manual

Page: 5 / 14

II. Methods of Operation
Plug Insertion
Insert the plug of switch cable
into the receptacle of the winch.
Tighten it by turning the locking
ring clockwisely.
Be sure to fix the switch cable
by snap hook. Do not allow the
cable to be caughted by wire rope and drum.
Up And Down Control
To lift a load, press the up button, the drum will rotate in the lifting direction.
To lower a load, press the down button, the drum will rotate in the lowering
direction.
Wire Rope Replacement
Insert the wire rope into the hole of drum and fix it with a P. T. screw, then press
the "UP" button of switch for rotate the drum in the lifting direction.
Wind the wire rope accurately around the drum, and a irregular winding will cause
the load to be swing, thus damaging the wire and reducing the lift of winch.
When replacing, according to the following procedures.
*
Pull out a R-dowel "D" from the round head pin "C".
*
Pull out a round head pin "Cc from hook body "A".
*
Put a wire rope "B" into the hole of hook body "A", and insert a round head pin
"C" through wire rope and fixture hole of hook body "A".
*
Insert a R-dower "D" into the hole of round head pin "C".