Comet CSW 700, Instructions And Operating Manual

Page: 33 / 188

EN - Instructions and operating manual CSW 700 B/G - CSW 900 B/G (translated from original instructions)
pag. 33
ƒ
In case of contact with acid:
- rinse any splashes in the eyes or on the skin with plenty of water;
- if necessary contact a doctor immediately;
- wash dirty clothes with water.
CHAPTER 8 – DESCRIPTION OF THE MACHINE
1) Battery cover (CSW 700/900 B only)
2) Protective case
3) Rh side case
3) Lh side case
u
SAFETY GUARDS:
As illustrated in
Fig. 4
it is possible to see the safety guards that must be intact and accurately installed. It is
not possible to use the machine with one or more missing or damaged guards.
The description of the safety guards are given below:
4) Rh safety net
4) Lh safety net
5) Front bumper
6) Cover for side brush
Fig. 4
1) Case switch (CSW 700/900 B only)
Fig. 4/A
u
SIDE BRUSH:
The side brush,
Detail 5 Fig. 4
, acts as a conveyor of the dust and rubbish and is only used to clean edges,
corners and borders; after these operations it has to be lifted up to avoid raising dust and also because the
cleaning effect of the side brush is always less than that of the main broom.
u
CENTRAL BRUSH:
The main brush, Detail 2 Fig. 5 is the main part of the sweeper. This brush collects and loads dust and rub-
bish in the refuse container; it is available with different types of bristles of different harnesses according to
the material to be collected; it can be adjusted in height when it is worn
( Ú see
Chapter 13
).
IMPORTANT: Never collect string, wires, packaging straps, sticks etc., that are longer than 25 cm as
they could wind around the side and main brushes.
u
FILTERING SYSTEM:
Thanks to the sweeper’s filtering effect no dust is seen in the environment when it is working. This is achie-
ved by means of filters
Detail 3 Fig. 5
; the filter system can be disengaged by pulling the knob
Detail 4 Fig.
6
upwards.
u
DUST GASKETS:
See
Detail 4 Fig. 5
. The gaskets surround the central broom and are essential to correct machine operation,
as they make the suction effect possible; it is therefore very important to check them very frequently.
u
REFUSE CONTAINER:
The refuse collector or container
Detail A Fig. 1
, is made in strong and resistant plastic and holds all the
material collected by the main brush and dust from the filters.
IMPORTANT: Disengage the filter when going over damp surfaces (if the machine is running)
otherwise the paper filters will get damp causing them to deteriorate quickly.