14
5.
Press and release the button to be associated with the function.
» Correct procedure indication
: the LED
flashes for a few seconds and a confirmation tone sounds.
6.
Exit programming mode by setting
S2
DIP 6
to OFF.
» LED
switches off
S2
7.
Set S2
DIP-switches 1-2-3-4
to ON.
8.
Return the S1 DIP-switch settings to their original combination.
Selective single or group intercom call: button configuration
First, the intercom call code needs to be set for each internal unit on the riser.
Proceed as follows:
1.
Make a note of the S1, S2 settings and
restore
them at the end of
the programming process.
2.
S1: Set an address. See Table B.
Example: 3
S1
3.
S2: Set the DIP-switches as shown in the figure.
S2
4.
x4
x10
OK prog:
KO prog:
x4
x10
OK prog:
KO prog:
Table B
Code
S1 DIP-switch ON
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
The same intercom call code can be associated with up to 3 devices.
Now proceed as follows:
2.
Make a note of the S1 DIP-switch settings.
3.
To enter programming mode, set S2
DIP 6
to ON.
» the LED
flashes
S2
4.
Refer to the table
to identify a DIP-switch 1-2-3-4 combination
in which the intercom function (INT) corresponding to the button you want to program
appears, then set the
S2
DIP-switches.
Example: For button X= Intercom (INT) set S2 DIP-switches 1-2-3-4 as specified in row "N"
in the table
Example
S2
5.
Use the S1 DIP-switch to set the
selective
address of the device you wish to call. See Table B.
For group calls, simultaneously set the desired selective addresses (max. 3) to ON.
6.
Press and release the button to be associated with the function.
» Correct procedure indication: the LED
flashes for a few seconds and a confirmation tone sounds.
7.
Exit programming mode by setting S2 DIP
6
to OFF.
» LED
switches off
S2
8.
Set S2
DIP-switches 1-2-3-4
to ON.
< BACK