3
The
WARNING
heading used in this manual explains dangers that might result in personal injury or
death.
Always read the associated information
very carefully before performing the indicated
procedure.
The
CAUTION
heading used in this manual explains hazards that could damage the unit. Such damage
may invalidate the warranty.
MUST
– This word is understood to indicate a mandatory condition.
HIGH VOLTAGE
– Voltages greater than 50 volts DC or 25volts AC and known to cause death or
serious injury if contacted.
SERVICE
– Any operation of maintenance, repair, calibration or similar activity other than the normal
operation of the unit.
QUALIFIED SERVICE TECHNICIAN, QUALIFIED ELECTRICIAN, QUALIFIED
PERSONELL
These terms indicate persons specifically trained to install, service or other wise handle
electronic equipment of the character and hazard potential of this unit.
End User Labeling
The system installer should obtain and apply all appropriate safety and warning labels required by the
end user’s local fire department jurisdiction and Occupational Health and Safety Administration over
and above those supplied by the generator manufacturer.
Read And Understand This Section Fully Before Installing or Operating This Equipment.
WARNING: This equipment must be installed, operated and serviced only by trained, qualified
persons.
General Safety Requirements
•
WARNING:
Hazardous Voltages and RF voltages are present inside this unit, which may cause
injury or death. To prevent electrical shock and or RF burns, never operate this equipment with the
covers removed. Never operate without an appropriate cable connected between the RF output
connector on the rear panel and the load.
•
CAUTION: There are no user or operator serviceable parts inside this equipment. Refer all
service to a qualified service technician.
•
This equipment must be bonded to Protectiv e Earth (safety ground) prior to operating the unit.
Safety ground connection must be made at the unit’s rear panel designated 1/4” - 20 threaded
ground stud. The ground wire should be a #14 awg or equivalent (minimum) green/yellow lead.
•
Replace fuses only with identical type and rating parts. Installation and connection of this
equipment must only be performed by a qualified electrician.
•
HEAVY OBJECT CAUTION:
A heavy object caution exists for equipment weighing more that
51 lbs or 23 kg. Use lifting aids to install unit, such as chain lifts or hooks and straps, attached to
the four handles at the sides and front of unit. Guide unit into final location using care to keep
hands and body parts clear of unit.
Summary of Contents for CPS-1001/S/13.56MHZ
Page 18: ...17 ...
