CombiSteel Bain-Mari 7478.0125, Instruction Manual

Page: 26 / 47

26/47
o
You must be sure that the feeding water has been installed and the water vane is turned on.
o
You must be sure that the wastewater installation was done properly and discharging hose was coupled with discharging pipe tightly.
10. START UP
The figures of control panel on the devices have been shown. According to these figures, as earlier mentioned, the device, whose
electrical connection was made fully and correctly, is operated by turning on control switches.
Turn on the thermostat to any position between 30 C°-120 C°-;pilot lights will com on; the green one shows that the appliance is
on the yellow one shows that the resistances are on.
When the thermostat lamp lights off, it means that the heater has reached desired temperature.
While the devices are in operation, do not keep burning material (plastic bags, table napkin, clothe etc.) near them.
Thermostat control switch for 30-120 ° C is set to desired temperature.
Do not operate the device out of the liquid levels which is under the min mark.
Do not operate the device out of the liquid levels which is up to the max mark.
After using the device, bring all control switches in to “0” position and switch off electric energy.
While device is in operation, the device, heater, top side and front panels reach to high temperature. Do not touch these parts in no
way.
CONTROL PANEL
7478,0125
A –Signal lamp heater on B – Signal lamb energy on C – 30-120 termostat