Combilift Ltd.
C4000-C5000XL O&S Manual
4-7
C4000-OM-EN-08
4.2: Initial Service – Conducted at 100 hours of Operation
The initial service is conducted at this interval to ensure that the truck is
optimum working condition upon leaving the factory. In order to complete the
initial service the following task must be completed.
Change engine oil & oil filter.
Replace fuel filter.
Check fan belt tension and adjust if required.
Replace hydraulic suction filter (located at rear of hydraulic tank)
Replace return filter (located on top of the hydraulic tank)
Check hydraulic oil level.
Check coolant level.
Check the machine for hydraulic, coolant and fuel
leaks.
Check air cleaner and replace if necessary.
Check all mast carriage-bearing lock nuts are tight.
Check all bolts and fittings are tight.
Check radiator, and if necessary, clean fins
Grease all points indicated on grease point chart
Check all wheel nuts for tightness.
Check mast chains; lubricate and adjust if required.
4.3: Engine Oil And Engine Oil Filter
(service Interval = 250Hours)
The engine oil used in the Combilift should have the correct temperature range
for the ambient temperature in which the machine is to be operating.
Temperature affects the viscosity of the oil and therefore its lubricating
properties. All Combilift trucks leave the factory with a special, high multi-grade
oil in the engine and this can be used all year round except in very cold
climates.
Note
All grease points indicated on the grease point chart MUST be greased
weekly using an appropriate EP2 Grease
Note
All wheel nuts should be checked daily and torqued every 250 hours:
Front Wheel nuts (210Nm or 155ft/lbs)
Back Wheel nuts (300Nm or 220ft/lbs)
https://www.forkliftpdfmanuals.com/