Combilift Ltd.
C4000-C5000XL O&S Manual
4-4
C4000-OM-EN-08
The Operational Checks (service Interval = Daily)
These checks are performed in order to ensure that every part of the
Combilift functions correctly and in a safe manner. The checks are
performed as follows:
Check the seat belt – Enter the cabin using the three point contact
method. Make sure that the seat belt functions correctly. Check for any
cuts or fraying along the belt and that it secures correctly into the
retainer. Always wear the seat belt provided when you are driving
the Combilift.
Check the seat – All Combilift machines come with adjustable air
suspension seats. The operator must ensure that the seat is correctly
adjusted for their individual height and weight. Instructions on how to set
the seat are in the operators’ manual.
Turn on the Machine – Insert the key into the ignition and turn the key to
the “On” position. This will allow power to flow through the electrical
system. Several lights should illuminate in the dash.
Test the horn – the horn button is on the dash to the right hand side of
the operator. The Truck should not be operated if the horn is not
functioning. Depress the button to test the horn.
Starting the engine - Ensure that the Parking brake is applied by
depressing the large red button on the dash. Also ensure that the
directional control lever is in the Neutral position. Turn the key to the start
position to start the engine and then release the key. It will return to the
on position.
Listen – Listen to the engine for a few seconds before driving off. Be
alert for any strange sounds or noises from the engine. Also be on the
look out for any strange odours that may indicate a problem such as a
very strong smell of gas or burning. If you detect anything, which is not
normal, stop the machine immediately and investigate the problem.
Check the Dash – look at the dash and make sure that the warning
lights are all extinguished. The only light that should be on after the
engine is started should be the parking brake. Should any other lights be
illuminated, stop the machine and report the fault to your supervisor. A
full list of all the gauges, indicators and controls along with each function
can be found in section 2 of the this manual.
Check the mast functions – After checking that there is adequate
space and headroom perform the checks on the mast functions. Raise
and lower the mast making sure that the operation is smooth and
controlled. Extend the mast forward and then retract it. Again watch for
any signs of sticking. Tilt the mast fully forwards and backwards. Then
test any auxiliary function that may be fitted to Your Combilift.
https://www.forkliftpdfmanuals.com/
