Gear
teeth
[-]
Number of teeth on the engine gear for the pick-up.
Set to zero, if no pick-up is used. Engine speed is counted from the generator frequency.
Step:
1
Range:
0 – 500
Hint:
Generator frequency can be used only when generator voltage (min 5V) is present before reaching of
the firing speed (
Starting RPM
) after start.
Nominal
RPM
[RPM]
Nominal engine speed.
Step:
1RPM
Range:
100 – 4000 RPM
FltRes GoToMAN
[ENABLED/DISABLED]
DISABLED:
Controller stays in AUT mode after Fault reset .
ENABLED:
Automatic switch from AUT (or TEST) to MAN mode after Fault reset to avoid
automatic engine start. This function is active for Shut down protection only.
DispBaklightTO
[min]
Timeout after which the display backlight is switched off.
Step:
1 min
Range:
0 – 60 min
Default value: 0 … means that the display lights all the time
ControllerMode
[ OFF, MAN, AUT ]
Equivalent to Controller mode changes by MODE
→
or
←
MODE buttons.
Hint:
Controller Mode change can be separately password protected.
*
RS232
mode
[STANDARD/MODBUS/CumminsMB]
Communication protocol switch.
Standard:
LiteEdit communication protocol.
Modbus:
Modbus protocol.
CumminsMB: Protocol for communication with Cummins engines via Modbus.
Hint:
For detail description see chapter Modbus protocol.
*NumberRings AA
[ - ]
Number of rings prior to open modem connection.
Step:
1
Range: 1 – 30
Hint:
NumberRings AA
change is not activated immedatelly. It is activated after controller is switched on or
when modem is connected to controller.
Engine params
Start RPM
[%]
“Firing” speed when iL controller stops cranking (starter goes OFF).
Step:
1% of nominal RPM
Range:
5 – 50 %
InteliLite – MRS10/11/15/16, SW version 2.2, ©ComAp – November 2004 29
IL-MRS-2.2.pdf