COMAC ABILA 42, Manual, Page: 10 / 22

30
MACHINE PREPARATION
BATTERY CHARGE LEVEL GAUGE
The batteries’ indicator is digital with 4 fixed positions and a blinking one. The numbers,
which appear on the display, show the approximate charge level.
4 = maximum charge, 3 = charge 3/4, 2 = charge 2/4, 1 = charge 1/4,
0 = (blinking) discharged batteries)
WARNING! Some seconds after that “0” blinks, the brush motor
automatically switches off. Anyway, the machine can finish to dry before
recharging the batteries.
INSTALLING THE SQUEEGEE
The squeegee is supplied separately from the machine, due to packing reasons. It must
be installed as shown in the picture, threading the retaining pin into the squeegee
column. Put the squeegee suction tube into its sleeve.
SQUEEGEE HEIGHT ADJUSTING
The squeegee height is to be regulated according to rubbers wearing. To adjust this:
rotate the wing nuts (1) anticlockwise to lift the squeegee and clockwise to lower it.
Note: The right and left wheels must undergo the same regulation, to allow the
squeegee to work parallel to the ground.
1
SQUEEGEE INCLINATION ADJUSTING
During the running, the back rubber is to be lightly inclined backwards (about 5 mm, on
its whole length). Should it be necessary, you can increase the rubber central inclination
by inclining backwards the squeegee body, turning the regulator anticlockwise (1). To
increase the bending of the rubber on the squeegee sides, turn the register clockwise.
Once the regulation is finished, lock the block nut.
5mm