Single brush machine
E 505 S Ex
1.8. Working position
The correct working position for operating the Columbus E 505 S Ex single brush machine is behind the handle
bar.
1.9. Approved maintenance personnel
The Columbus E 505 S Ex single brush machine must only be maintained and repaired by the manufacturer G.
Staehle, D-70372 Stuttgart or by those approved (and properly trained) by the manufacturer. To ensure that the
single brush machine meets all technical requirements and the existing safety regulations during operation, we
suggest that you conclude a Columbus G.Staehle Maintenance Agreement.
1.10.
Conduct in case of emergencies
Release both levers and keep a firm hold on the single brush machine until the
scrubbing brush has stopped. Then immediately pull out the mains plug to disconnect
the appliance from the power supply.
2. Descritpion
The Columbus E 505 S Ex single brush machine is used for wet scrubbing of hard surfaces, especially inside
buildings.
The Columbus E 505 S Ex single brush machine must only be used with the cleaning tools shown in point 6
and point 1.4.
3.
Delivery
The Columbus E 505 S Ex single brush machine is delivered fully assembled with the handle already attached.
The single brush machine is provided with of a mains connection cable with strain relief at the handle.
After you have read the operating manual, the single brush machine is ready for use.
4. Inserting the cleaning tool
Only use the cleaning tools shown in point 6 and point 1.4.
Only install the cleaning tool by hand.
ATTENTION!
First disconnect the mains plug!
First put the handle (5) in a vertical position. Release the handle
(5) by pulling the positioning lever (2) on the switch housing (4).
Rotate the handle until it is vertical. Fix in place by releasing the
lever.
Release the main body by pressing the pedal situated between the
wheels.
Tilt the machine backwards so that the control unit (4) is resting on
the floor.
Insert the scrubbing brush (13) into the drive disc (14) with a short,
sharp turn to the left; then set the machine upright again
6
