11 Colortrac SmartLF Gx+ Range Installation and Operating Manual
PAS176 P/N: P005530 Colortrac Ltd © 2010
THE SCANNER CONTROLS
The scanner controls for document positioning become active as
soon as the scanner reaches the ready state, normally 10 seconds
after switching on the scanner. Documents can be loaded, moved
and cancelled using the FWD, BACK and CANCEL buttons (shown
dotted).
TAKE CARE TO
LOAD BETWEEN THE SINGLE LINES AS
THESE REPRESENT THE MAXIMUM ALLOWABLE DOCUMENT
WIDTH. SCANNING DOCUMENTS BEYOND THESE
BOUNDARIES MAY CAUSE DOCUMENT DAMAGE
.
To adjust the load time
period or „Load Timeout‟ see section 4.8
LOADING A DOCUMENT
For maximum document alignment accuracy always try to
place the document into the scanner with the longest edge
of the document towards the scanner opening and rollers.
Feed the document until it meets the internal roller. After a
short time period the scanner will automatically detect the
document and load it ready for scanning.
REMOTE CONTROL
With Colortrac software the FILE and COPY buttons on the scanner control panel duplicate the normal software
normally controls accessed with the mouse. Note that the FILE and COPY buttons on the scanner are not able to start
the software and these must be started using the Windows operating system BEFORE the scanner panel will be able
to activate FILE and COPY remotely.
3.2 Document Load Controls
These buttons operate without the scanner connected to a computer as soon as the scanner has initialised.
PRESS
FUNCTION
REASON
CANCEL -
during load aborts and
rewinds document
To remove a loaded or
skewed document
(temporary command)
FWD -
forward advances a loaded
document until button is released
To fast-forward a loaded
document
FWD -
ejects a held document
To eject a document
that has been scanned
but not released
BACK -
rewinds a loaded document
To reload/ reorient a
document
