NOTES:
Cx40 Service Manual
Page 33 of 80
15. Making sure the CIS is seated right down in the slot, using an Allen
key, tighten the 2 x grub screws until they are finger tight against
the CIS. It must be tight enough to hold the CIS in place against the
far side wall of the slot, but not so tight as to cause any distortion in
the CIS itself. Repeat this process for all CIS arrays being replaced
or refitted.
16. Refit the 2 x retaining bars to hold the CIS in and prevent them
from moving and falling out when the mounting bar is replaced. The
screws should be tightened so the bar is down against the CIS, but
not so that it starts to move, or apply pressure, to the CIS in any
way.
