21
www.colormetrics.info
Colormetrics P1300
22
6-
1. MagSwipe Card Reader /i
-
Button reader Configuration utility
The MagSwipe Configuration utility is used to set up the output format of MagSwipe
CIDTestAp V07.01 Operation Manual
1. Device Connection
2. Utility Features
3. Configuration Setup
Version: V01.00 .
1.
Device Connection
1. USB(HID) Interface
Select the USB HID device which has been plug into the PC USB port, enter the
correct Vendor ID = 0E6A and Device ID then press ‘OK”, different device has its
own Device ID., e.g. DID=0x030F for keyboard and HID USB, DID=0x5082 for
keyboard, HID and VCP USB.
2. Utility Features
After success device connection each supported command will get its response, e.g.
Get Version command should response with the device HW/FW version, for all
command set supported please reference its programming guide.
There are two command/response windows can be used (see block1 & 2).
Device Driver Installation
6
23
For second level device the Indirect command signal should be selected (see block3 & 4). Press
the button “Configure Word” to enter the parameter setting function (see Block 5). The two
response windows show up the data from the device connected.
2.
Configuration Setup
Device functions(e.g. MSR, i
-
Button, RFID, Chip card) behavior can be defined and
stored by this tool.
Four operation buttons define as below:
“Load From File”: Load the previous setting configuration file from storage.
“Save To File”: Save the current screen setting to file in storage.
“Get Configuration Word”: Get current setting in the device connected.
“Set Configuration Word”: Set current setting on the screen to the device connected.