Page
28
User’s Manual
After pressing “
Store
” a new menu will appear, Pause Length. This is how long the searchlight
will stay at this position until starting to move to the next position. Pause length can be set
between zero and ten seconds.
Repeat this for the desired number of positions wanted in a surveillance sweep.
When done go back to the “
Surveillance
” submenu by pressing “
Back
”. Navigate to “
Start
” and
press “
OK
” to start the surveillance sweep.
11.3.2 Changing surveillance settings
Surveillance has a couple of different settings,
“
Loop Mode
” and “
Speed
”.
In “
Loop Mode
” there are two choices, “
Back and Forth
” and “
Repeat
”.
When using “
Back and Forth
” the surveillance sweep will go from position one to two and so on
until it comes to the number set in “
Number of Positions to Use
” then it will go back to the
previous position.
When using “
Repeat
” the surveillance sweep will go from position one to two and so on until it
comes to the number set in “
Number of Positions to Use
” then it will go to position one instead
of going to the previous position.
To set “
Back and Forth
” or “
Repeat
” enter the “
Surveillance
” submenu then “
Loop Mode
”.
