Page
17
of
42
SoniQ HQ Plus
Note:
Please take care about the following points while handling the media:
•
Media should be even
•
Media roll sides (edges) should be straight or even.
•
Media clamp should be properly and evenly placed on the media edges. In case, media clamps are
damaged or bent then replace it immediately.
•
Carefully monitor media shifting (may cause wrinkles) and head nozzles get damaged.
Step 8
: Pull the enough media so that it reaches to the Take Up roller (Optional) or let the media down by
issuing the Print command).
Step 9
: Paste the front edge of the media on the core.
Step 10:
Turn on the Take Up System and observe the media direction (either reverse or forward), as shown
below:
Fig 17: Enabling the Take-Up System
Step 11:
Move the media forward so that it rolls easily over the Core.
Step 12:
Adjust the bed vacuum to firmly hold the media as per the media type, using the
Bed Vacuum
regulator.
Now, the media gets loaded.
Note
: Before issuing the Print command, verify the following things:
•
Check the Waste Bottle and empty it, if required.
•
Check the ink level in main tanks and refill it, if required.