EN
9
Installation instruction
Please use the enclosed drilling/size template to help you
with the installation! The letters
a
to
c
below refer to the
features of the drilling/size template.
1. Hold the drilling/size template against the surface where
you wish to install the lamp.
Do not mount the lamp directly above a sauna stove
-– risk of overheating!
2. Drill a hole with a diameter of at least 13mm for the
power supply cable in the position marked
a
.
3. If you wish to pre-drill holes for the clip screws, drill 4
holes with a diameter of 3mm in the four positions
marked
b
.
4. If the sauna temperature is high, the lamp will be dimmed
automatically to protect itself. If you wish to prevent this
effect, you can cut out the rectangular profile
c
from
the ceiling instead of drilling the hole in the position
marked
a
.
5. Feed the power supply cable from above through the
hole in the ceiling and plug it into the diode.
6. Position the diode appropriately and carefully pull the
cable back so that it is neither caught nor unplugged.
7. Fasten the diode with the 4 enclosed clip screws in the
positions marked
b
.
8. Pull the protection film off the diode.
9. Clip the wooden frame onto the diode and ensure that
all 4 clips have engaged – you will hear a locking sound
and can also feel the clips catching.
10. Plug the power supply unit into the mains socket.
Operating instructions
Please also refer to the illustration on the back of these
instructions for explanation!
|
Next button
Switches to the next colour and activates the single colour
mode.
This button can also be used to switch the lamp on.
Pressing this button for a while will switch the lamp off.
~
Automatic button
Switches to the next colour and activates the automatic
mode.
This button can also be used to switch the lamp on.
Pressing this button for a while will switch the lamp off.
Colour sequence
The colours change in the following order:
red – orange – yellow – green – turquoise – blue – purple
(– red...)
Completely dim up for white light.
}
Brighter button
To increase the light intensity.
This button can also be used to switch the lamp on.
{
Darker button
To decrease the light intensity.
This button can also be used to switch the lamp off.
Brightness sequence
From dark to bright, you go through the following settings:
off – dimmed pure colours – brightest pure colour – pastel
colours – white
(only in single colour mode)
